This is especially important when you use the Custom encryption option. VPN encryption settings must be the same on both sides (the local gateway and the peer gateway).

Make sure the certificate is trusted on both sides. You must reinitialize certificates with your IP address or resolvable host name. In this Site to Site VPN configuration method a certificate is used for authentication. See Viewing VPN Tunnels.Ĭonfiguring Site to Site VPN with a Certificate Go to VPN > VPN Tunnels to monitor the tunnel status. Send traffic between the local and peer gateway. For more information, see Configuring VPN Sites. If it is a DAIP gateway, its host name must be resolvable.Įnter a host name or IP address and enter the preshared secret information. The peer device that you connect to must be configured and connected to the network. See Configuring the Site to Site VPN Blade. Make sure the Site to Site VPN blade is set to On and Allow traffic from remote sites (by default) is selected. In this Site to Site VPN configuration method a preshared secret is used for authentication. Configuring Site to Site VPN with a Preshared Secret Use the configured client to connect to an internal resource from a remote host. See Configuring Remote Access Authentication Servers.Ĭlick permissions for Active Directory users to set access permissions.įor L2TP VPN Client configuration, click L2TP Pre-shared key to enter the key after you enable the L2TP VPN client method.įor more information on advanced Remote Access options, for example Office Mode network, see Configuring Advanced Remote Access Options. Go to VPN > Authentication Servers and click New to add an AD domain. See Configuring Remote Access Authentication Servers.Ĭlick permissions for RADIUS users to set access permissions. To configure RADIUS users:Ĭlick Configure to add a RADIUS server. Make sure that the Remote Access permissions checkbox is selected.įor more information, see Configuring Remote Access Users.Ĭlick Edit to make sure that the Remote Access permissions checkbox is selected.įor more information, see Configuring Remote Access Users.Select the arrow next to the Add option and select the relevant group option.

To allow only specified users to connect with a remote access client, set group permissions for the applicable user type. These are the methods to configure remote access users: Click How to connect for more information. See Configuring DDNS and Access Service.įor the Check Point VPN client or Mobile client method, make sure that the applicable client is installed on the hosts. If the gateway uses a dynamic IP address, we recommend you use the DDNS feature. Select the applicable connection methods.įor more details, see Configuring the Remote Access Blade. Remote Access control is set to On and the Allow traffic from Remote Access users (by default) option is selected. Site to site VPN using a preshared secret This section describes how to configure these VPN configuration scenarios:

Checkpoint remote vpn